Titan SF16N-9, Инструкция по безопасности и эксплуатации

Страница: 12 / 17

when the machine is at a standstill.
-Lower the drilling spindle (11) until the tip of the
drill bit touches the workpiece.
-Slacken the depth scale lock (14) and turn the
scale ring (24) forwards until it stops.
-Turn the scale ring (24) back to the desired drill
depth, then lock this setting into place using the
depth scale lock (14).
11.SETTING THE ANGLE OF THE DRILL
TABLE
(See Fig 5)
- Slacken the carriage bolt (25) under the drill
table (4).
- Set the drill table (4) to the desired angle (which
can be read off the scale on the top side of the
drill table).
- Tighten down the carriage bolt (25) in order to
lock the drill table (4) into this position.
12.SETTING THE HEIGHT OF THE DRILL
TABLE
(See Fig 1)
- Slacken the tightening screw (5).
- Set the drill table (4) to the desired height by
pressing down or lifting up and simultaneously
(gently) pushing to the left or right.
-Screw the tightening screw (5) back down again.
13.NEVER HOLD THE WORKPIECE IN PLACE
WITH YOUR HAND!
When drilling you must ensure that the workpiece
can move freely in all directions .This will allow
you to precisely locate the drill bits.
Always ensure that the workpiece cannot rotate.
Caution!
Sheet metal parts have a tendency
to “snatch” (rise up the dill bit) suddenly
unexpectedly always. Ensure workpiece is securly
clamped before drilling.
There must be enough distance (>10mm) between
the upper edge of the workpiece and the tip of the
drill bit.
14.COUNTERSINKING AND CENTER-
DRILLING
With this table drill, you can also countersink and
center-drill. Please observe that countersinking
should be performed at the lowest speed, while a
high speed is required for center-drilling.
15.CARE AND MAINTENANCE
The table drill is to a large extent maintenance-
Fig 8
Fig 9