Titan SF16N-9, Инструкция по безопасности и эксплуатации

Страница: 10 / 17

operation, adjustment and maintenance.
Note:
The fixing screws may only be tightened
to a point where they do not distort or deform
the base plate. Excessive tension can lead to
fracture.
4.HINGED CHIP GUARD
(See Fig 4)
Unscrew the three-recessed head screws (20).
Push the transparent cover (22) into the groove of
the red mounting frame (23) and fasten it again
with the recessed head screws (20).
The height of the cover (22) is infinitely adjustable
and can be locked using the two thumb screws
(21).
The chip guard (13) can be flipped upwards to
change drill bits; ensure, however, that the chip
guard (13) is back in its initial position before
restarting the machine.
5.PRIOR TO STARTING
Ensure that the voltage of the mains supply
complies with the specifications on the rating
plate. Connect the machine only to a socket with
the properly installed earthing contact.The table
drill is equipped with a no-volt trip that is designed
to protect the operator from an undesired restart
following a drop in voltage. Should this occur, the
machine must be manually restarted.
6.OPERATION GENERAL
(See Fig 2)
To switch on the machine, push in the green On
button “l” (17); the machine starts up. To switch
off, press the red Off button “o” (18); the device
shuts down. Ensure that you do not overload the
device. If the sound of the motor drops in pitch
during operation, it is being overloaded. Do not
overload the device to the point where the motor
comes to a standstill.
The machine is designed for continuous operation
with intermittent load (S2 :15 min).
The machine may be operated under a full load
for a maximum of 15 minutes, at which time
the machine needs to idle for 15 minutes. This
prevents the motor from overheating.
7.INSERTING THE TOOL
(See Fig 1)
Make sure that the power plug is removed from
the socket-outlet before changing tools. Only
cylindrical tools with the stipulated maximum
shaft diameter may be clamped in the scroll
Fig 4
Fig 5