Titan SF16N-9, Инструкция по безопасности и эксплуатации

Страница: 13 / 17

9 SPEED BENCH PILLAR DRILL SF16N-9
free.
Keep the device clean.
Pull out the mains plug before doing any cleaning
and maintenance work on the machine.
Do not use any harsh, abrasive cleaning
solvents.
Ensure that no liquid seeps into the device.
Re-gress all bare parts when the work is finished.
The drill pillar, blank parts of the column, and
the drill table especially should be regressed
at regular intervals. Use standard, acid-free
lubricating grease to do this.
Regularly check and clean the ventilation holes.
Store the device in a dry room. Should the
device become damaged, do not try to repair it
yourself; leave this work to a qualified electrical
technician.
16.ASSEMBLY OF THE CHUCK
Holding the chuck on the spindle, tap with a block
of wood hammer or a soft tip hammer to set the
chuck onto the spindle. (See fig9)
17.DISASSEMBLY OF THE CHUCK
Disconnect the bench drill from the power supply.
Fit a suitable length bolt through the work table
hole, do not tighten it (See fig10).
Adjust the work table to a suitable height and lock
the work table. Move down chuck and tighten the
chuck onto the bolt (See fig11 & 12). Turn handle,
move up spindle. Chuck will be pulled off.
Fig10
Fig 11&12