5
WARNING
Read and follow all instructions for assembly and operation. Failure to properly assemble this
equipment could result in serious injury to the user or bystanders, or cause equipment damage.
Engine Shipped Without Oil.
Before starting engine, fill with SAE 10W-30 motor oil.
See engine manual for engine oil capacity.
Hydraulic Reservoir is Shipped Without Oil.
When adding oil verify the oil level reads 1 from the top of hydraulic
reservoir if marking is not shown fill to the neck.
Inspect all Log Splitter Components.
If you have damaged components:
Contact the freight company
that delivered the log splitter and file a claim.
30 TON LOG SPLITTER ASSEMBLY
Set the shipping crate on a solid flat surface and carefully remove the lid. Use two people and take all
parts out of the shipping crate and inspect the components to ensure there are no missing pieces
before starting to assemble the log splitter follow steps 1 through 8.
TOOLS REQUIRED
•
Rubber or Wooden Hammer
•
13mm, 16mm, 17mm, 18mm, 19mm, 24mm, 27mm Wrenches
•
Large Adjustable Wrench
•
Phillips Screwdriver
•
Pliers
STEP 1: WHEEL ASSEMBLY
1. Attach the wheel (#35) to the oil tank axle (#44) using a flat washer Ø20 (#54) and tighten the
wheel with the hex slotted nut M20x1.5 (#37). Lock the hex slotted nut M20x1.5 (#37) in place
using the cotter pin Ø4x36 (#73). Install the axle cap (#41) on the end using rubber hammer.
NOTE:
Use a black plastic bushing to fix the axle cap (#41) like below
picture. Please cover the black bushing onto the axle cap and use
rubber/wooden hammer knocking the end of the plastic bushing and
make the axle cap fixed on wheel.
ASSEMBLY INSTRUCTIONS
