User Manual-VN1
Version C July 2020
6 of 23
6
2.
Installation
Mechanical installation
2.1
Mounting notice
2.1.1
Use solid mounting pins with the proper dimensions and support them at both ends.
As shown below, please mount the actuator with the mounting pins of correct dimension and
without threaded at both ends of the attachments.
Do not mount the actuator with the pins in different rotated angles, this could cause stress on the
nut during operation.
The load should act along the stroke axis of the actuator from the front attachment, inner tube to
the rear attachment. Off center or side loads may cause bending and lead to failure.
Be sure the mounting pins are parallel to each other. If the pins are not parallel to each other the
actuator might bend and could be damaged.
YES
X
X
NO
Y
X
