User Manual-TA2P
Version C May 2020
14 of 21
14
2.3.4 Two limit switches send the signal and an additional limit switch sends
a signal at specific stroke positions
The actuator is equipped with two limit switches at the end of the strokes. When the actuator moves to the
end of each stroke, each limit switch sends out the end of stroke voltage signal and an additional limit switch
sends out the signal at specific stroke positions.
Wire
AWG
Description
Spec
Yellow 20
Connect to Vm+ to extend the actuator.
Connect to Vm- to retract the actuator.
24V version: Input voltage 18~32 V DC.
12V version: Input voltage 9~16 V DC.
Green
20
Connect to Vm- to extend the actuator.
Connect to Vm+ to retract the actuator.
Red
26
Connect to common pin (C.)
The signal, NOT potential free, actively
outputs voltage at the end of each stroke
and when the actuator moves to the position
where the middle limit switch is triggered.
Both the white and blue signal wires are a
normal closed circuit when the actuator is in
the middle of the stroke.
The middle limit switch, installed in position
by customer request, is factory preset and
non-adjustable
Connect the middle limit switch signal with
max 32V, <1A.
White
26
Connect to up limit switch normal closed
pin (N.C.)
Blue
26
Connect to low limit switch normal closed
pin (N.C.)
Black
26
Connect to middle limit switch normal
closed pin (N.C.)
Yellow
Green
Red
White
Blue
Black
