User Manual-TA2P
Version C May 2020
16 of 21
16
2.3.6 Two limit switches and a single Hall sensor
The actuator is equipped with two limit switches to cut the current of the motor when the actuator moves to
the end of each stroke, and with a single Hall sensor sending position signal output.
*Please refer to 2.3.2 for the cut current module.
Wire
AWG
Description
Spec
Yellow 20
Connect to Vm+ to extend the actuator
Connect to Vm- to retract the actuator
24V version: Input voltage 18~32 V DC
12V version: Input voltage 9~16 V DC
Green 20
Connect to Vm- to extend the actuator
Connect to Vm+ to retract the actuator
Red
26
+5V DC input signal power for Hall sensor
board.
Hall sensor output signal type is square
wave with Hi voltage 5V and Low voltage
0V, and with the output current of 0.1A
(please refer to the approval drawing for the
resolution and details).
Hall sensor circuit is independent to motor
power circuit.
White
26
Output Hall sensor signal during the
actuator moves.
Black
26
Hall sensor signal ground.
Yellow
Green
Red
White
Black
