EN
W415-1463 / F / 10.11.18
33
maintenance
At the end of each burning season inspect the shield and gasket below the manifold for warping or deterioration.
Replace if necessary. Both are held to the manifold with machine screws. The shield and the 1/8” (3.2mm) fibre
cloth gasket are available from your Wolf Steel Ltd. dealer. At this time also check that the door gasket is not worn
or loose. Replace with 3/8” (9.5mm) high density fibreglass rope if necessary.
The airwash gasket and shield above the door should also be inspected and replaced if deteriorated
8.5 door glass replacement
8.6 gasket replacement
8.7 care of glass
38.1
!
WARNING
• Do not use substitute materials.
• Glass may be hot. Do not touch glass until cooled.
• Care must be taken when removing and disposing of any broken door glass or damaged components. Be
sure to vacuum up any broken glass from inside appliance before operation.
• Do not strike, slam, or scratch. Do not operate appliance with glass removed, cracked, broken, or scratched.
38.1.1
Replacement glass/frame assembly shall be replaced as a complete unit as supplied by the appliance
manufacturer.
THIS TEMPLATE MUST BE USED WITH 38.1
!
WARNING
If the glass is not kept clean, permanent discolouration and/or
blemishes may result. Normally a hot fi re will clean the glass. The
most common reasons for dirty glass include:
• Not using suffi cient fuel to get the appliance thoroughly hot.
• Using green or wet wood.
• Closing the draft so far that there is insuffi cient air for complete
combustion.
If it is necessary to clean the glass, buff lightly with a clean dry cloth and non-abrasive cleaner. Clean the glass
after the fi rst 10 hours of operation with a recommended appliance glass cleaner. Thereafter, clean as required.
The glass is very strong, but do not let burning fuel rest or fall against it and always close the door gently.
NEVER FORCE OR SLAM IT SHUT!
Do not operate the appliance with broken glass, as leakage of fl ue gases may result.
Contact your local authorized dealer/distributor for complete cleaning instructions.
If the glass should ever crack or break while the fi re is burning, do not open the door until the fi re is out. Do not
operate the appliance until the glass has been replaced. Contact your local authorized dealer/distributor for
replacement parts.
DO NOT SUBSTITUTE MATERIALS.
5.3
• Do not clean glass when hot! Do not use abrasive cleaners to clean glass.
LA VITRE CHAUDE
CAUSERA DES
BRÛLURES.
NE PAS TOUCHER
LA VITRE
AVANT QU’ELLE AIT REFROIDI.
NE
JAMAIS LAISSER LES ENFANTS
TOUCHER LA VITRE.
HOT GLASS
WILL CAUSE BURNS
.
DO NOT TOUCH
GLASS UNTIL
COOLED
.
NEVER
ALLOW CHILDREN TO
TOUCH GLASS
.
!
DANGER
!
AVERTISSEMENT
A barrier designed to reduce the risk of burns from
the hot viewing glass is provided with this appliance
and shall be installed for the protection of children
and other at-risk individuals.
Une barriére conçu à réduire le risque de brûlures
causées par le verre chaud est fourni avec l’appareil
et sera installé pour la protection des enfants et
d’autres personnes à risque.
LA VITRE CHAUDE CAUSERA
DES BRÛLURES.
NE PAS TOUCHER LA VITRE
AVANT QU’ELLE AIT REFROIDI.
NE JAMAIS LAISSER LES
ENFANTS TOUCHER LA VITRE.
HOT GLASS WILL CAUSE
BURNS.
DO NOT TOUCH GLASS UNTIL
COOLED.
NEVER ALLOW CHILDREN TO
TOUCH GLASS.
!
WARNING
!
AVERTISSEMENT
Care must be taken when removing and disposing of any broken glass or damaged components. Be sure to
vacuum up any broken glass from inside the appliance before operation.
note:
Do not operate the appliance if the manifold shield or fibre baffle is deteriorated or missing.
note:
