Timberk TEC.PF3 LE 2000 IN, Инструкция по эксплуатации

Страница: 7 / 24

www.timberk.com • electric convector heater
7
Fig. 8
10 9 8
3 4 7 12 5 6 2
1 13 11
3. Set temperature
3.1. Temperature can be set within the range +5 to +30°C.
3.2. Turn the thermostat handle clockwise to the stop to position “max”, at
that if room temperature is below the set one, then the “heating” indicator
light must be illuminated. When the room temperature reaches the desired
level, turn the thermostat handle counterclockwise until the unit is switched
off, the “heating” indicator light will go out. Now the thermostat will maintain
the set temperature, switching on and off the convector from time to time.
During especially cold weather the convector may not be able to provide
the required room heating. In this case set the thermostat to the level
somewhat higher than the desired one.
4. «Antifreeze» mode
Turn the thermostat handle counterclockwise to position “min”. The
thermostat will automatically switch on heating of the convector, if the room
temperature goes below +5°C and the unit is connected to electric mains
and the heating mode is on.
5. «Comfort» mode
«Comfort» mode, which can be selected by means of the thermostat
handle, corresponds to the most comfortable room temperature.
1. Button « »
It is used to switch on and off the convector.
2. Power indicator « »
It is illuminated when the unit is connected to electric mains.
TEC.PF3 EL...IN series control panel (Fig. 8)
14
3. LED-display
LED-display can show temperature and timer settings.
4. Comfort mode indicator « »
It is illuminated when the convector is operating in the comfort mode.
5. Air ionizer indicator « »
It is illuminated when the air ionizing function is activated.
6. Heating indicator « »
It is illuminated when the convector is operating in the heating mode.
7. Economy operation mode indicator « »
It is illuminated when the convector is operating in the economy mode.
8. Button « »
It is used to select the following operation modes: comfort mode (indicator
« »), economy mode (indicator« »), antifreeze mode (symbol «AF»).
9. Ionizer button « »
It is used to turn on/off air ionizing.
10. Button «up» (« »)
It is used to increase the selected value.
11. Button “down” (« »)
It is used to decrease the selected value.
12. Timer indicator « »
It is illuminated when the convector switch off timer function is activated.
13. Button « »
It is used to set temperature in the comfort mode (indicator « »), in
the economy mode (indicator « »), as well as to set the timer (indicator
« »).
14. Two-button switch, with display
It is used to select the following heating power modes: 1 mode (low power),
2 mode (medium power), 3 mode (high power).
Operation of TEC.PF3 LE…IN series convector
1. Switch on the convector
Connect the convector to electric mains by plugging the power cord into an
electric outlet, at that a red power indicator « » will be illuminated on the
control panel and a sound signal will be given, then press button « ».