Timberk Power Door Series, Инструкция по эксплуатации

Страница: 24 / 32

IM2020
24
- install the panel and the top cover (instructions for installing the remote control and mounting kit
are included).
3. To connect the air curtain to the electrical network, remove the cover on the upper side of the
housing, insert a power cable and connect it to the terminal block of the curtain in accordance
with the marking.
ATTENTION!
1. The electric wire connected to the outlet from the power board must have a core cross section
of at least 1.5 mm
2
(for copper wire).
2. A three-phase circuit breaker designed for a rated current of 16A must be installed in the
power panel to protect the wiring from overloads.
THC WT1 12M, THC WT1 18M, THC WT1 24M models
1. The curtain is designed to be permanently connected to an alternating current electric network
with a three-phase voltage of 380V ~ (allowable voltage fluctuations from 342V ~ to 418V ~) and
a ground loop.
2. Before connecting the curtain to the electrical network, it is necessary to install an external
control panel connected at the factory. To do this it is necessary to:
- unscrew the screw on the control panel,
- remove the top cover and remote control panel,
- mount the remote control on the wall,
- Install the panel and the top cover (instructions for installing the remote control and mounting
kit are included).
3. To connect the curtain to the mains, remove the perforated curtain cover, insert the power
cable and connect it to the terminal block of the curtain in accordance with the marking. The
power cable must be secured with a cable gland or cable sealant (not supplied). A hole with a
diameter of 40 mm is provided on the upper side of the device to enter the power cable.
4. For THC WT1 12M model, the electric wire connected to the device from the power board
must have a core section of at least 2.5 mm
2
(for copper wire), for THC WT1 18M model - at
least 4.0 mm
2
(for copper wire), for THC WT1 24M model - not less than 6.0 mm
2
(for copper
wire).
5. To protect the wiring from overloads, a three-phase circuit breaker must be installed in the
power panel, enough for rated current of 25A for the model THC WT1 12M, 32A for the model
THC WT1 18M, 40A for the model THC WT1 24M.
8. OPERATION OF THE DEVICE
THC WТ1 3M, THC WT1 5M control panel
Fig.3*