TILLYTEC MAXI UNI, Руководство пользователя

Страница: 5 / 8

-5-
User manual Maxi uni
•
After the space holder is screwed hand tight, the battery tube is screwed together with the battery in the lamp
head to see if the torch is working.
Screw the battery tube only slightly ! not strong ! Screw it only until the
torch is on. Repeat the turning on and off several times and watch the LED module . But never look directly
into it ! When switching on and off the LED module should not or only very little rotate (only a few millimeters).
If the LED module rotates to much the space holder is too loose.
•
Please check the space holder every 15 to 20 dives and if it is nessesary please screw it a little bit
stronger !
IMPORTANT !
To ensure the tightness of the torch please grease the parts as following is shown regulary:
•
The three O-rings on the lamp head ( 1 ) are only visible, when the torch is opened to change the LED Module.
In this case please grease always these O-rings !
•
The tread of the space holder ( 2 ) inside please grease all 10 - 20 dives . This do only in the range of 10 - 15
mm from the beginning of the hexagon . The tread of the spacer ( 2 ) outside always grease when the LED
module is changed .
•
The three O-rings in the protective ring (3) are only visible when the space holder (2) is completed removed.
When the LED Module will changed
always grease the three O-rings.
•
The three O-rings on the battery tube ( 4 ) are always visible, when the battery tube is unscrewed This must be
greased
at least every 10-20 dives regularly or whenever the lamp is not used for a long time ( approximately
3 months ) .
GREASE MEANS : It is to see a glossy film - it is not swimming in grease !
Battery tube (4) protective ring (3) space holder (2) light head (1)