TILLYTEC MAXI UNI, Руководство пользователя

Страница: 4 / 8

-4-
User manual Maxi uni
Notes for using of charger
•
The hints of the operating instructions of the manufacturer are to be observed.
•
The charger has several LED lamps that indicate the progress of the battery charge.
•
The charger can connected to the battery verytime. You do not have to discharge the battery !
IMPORTANT: Use chargers only indoor or in dry rooms. The voltage values and settings must be
respected.
Burn time and light power
•
The burn time and the light power of the torch depends on
- the used LED modul
- the used type of battery or accumulator.
TIP : When the LED module of the MAXI uni basicis not bright enough
we will send a stronger LED module for trial for free.
•
More information about burning time and light power you will find on www.TillyTec.de –
on register „information“.
Operation and Handling / Changing the LED moduls
•
To turn your torch on and off, rotate the torch head. A half rotation is sufficient to engage the contacts. Further
rotation when switching off is not a problem as the system is protected with 3 O-rings, however it should be stopped
when the first O-ring is visible.
•
Change the LED modul as following :
- turn the protective ring (3)
- unscrew the space holder (2)
- remove built-in LED – modul (4) (some models have three screws to hold the LED
module, please remove in that case)
- install the new LED – Modul (4) (screw on the LED module if it has holes and
screws !)
- first turn the space holder (2) , tighten by hand*1)
- screw the protective ring (3) to the light head (1)
IMPORTANT : Tighten the space holder very strong by hand. Otherwise the cooling of
the LED module is not enough. So the LED module will be destroyed immediately !
*
1)
What does it mean „tighten by hand!
•
The space holder is hand tightened to press the LED module against the glass. This is necessary so that the LED
module can be cooled well.
Without cooling the LED module is destroyed ! The space holder should be clean
and free of grease on the flat side, where the LED module lies cloosly for cooling (cooling paste may be used).If you
use a version where the LED module is screw on the pace holder with socket screws, please screw the LED –
module tightly tot he space holder.