TILLOTSON TPP-4500G-A, Руководство пользователя

Страница: 25 / 30

25
!
Check that the spark plug washer is in good condition.
Thread the spark plug in by hand to prevent cross-
threading.
!
After the spark plug is seated, tighten with the spark plug wrench to compress the washer.
•
If installing a new spark plug, tighten
½
turn after the spark plug seats to compress the
washer. If reinstalling a used spark plug, tighten
⅛
-
¼
turn after the spark plug seats to
compress the washer.
Caution: The spark plug must be securely tightened. An improperly
tightened spark plug can become very hot and could damage the engine.
Never use spark plugs which have an improper heat range. Use only
recommended spark plugs or equivalent.
Spark Arrester Maintenance
If the generator has been running, the muffler will be very hot. Allow it to cool before proceeding.
The spark arrester must be serviced every 100 hours to maintain its
efficiency. Clean the spark arrester as follows:
!
Loosen the screw by the exhaust port of the muffler and remove the
spark arrester.
!
Use a brush to remove carbon deposits from the spark arrester
screen. Inspect the screen for breaks or tears and replace it if
necessary.
!
Install the spark arrester in the reverse order of removal.
INSPECTION, CLEANING AND MAINTENANCE
WARNING! ALWAYS MAKE SURE THE ENGINE POWER
SWITCH IS IN ITS “OFF” POSITION. DISCONNECT THE SPARK
PLUG WIRE FROM THE ENGINE. AND ALLOW SUFFICIENT
TIME FOR THE ENGINE AND GENERATOR TO COMPLETELY
COOL
BEFORE PERFORMING ANY INSPECTIONS,
MAINTENANCE OR CLEANING.
!
Before each use, inspect the generator. Check for:
•
Loose screws
•
Misaligned or bound moving parts
•
Cracked or broken parts
•
Damaged electrical wiring
•
Any other condition that may affect safe operation.
!
If an engine problem occurs, have it checked by a qualified service technician before further
use. Do not use damaged equipment.
!
Before each use, remove all debris with a soft brush, rag, or vacuum.
!
Lubricate all moving parts using premium quality, lightweight machine oil.
!
Every 50 hours of use, drain the old engine oil and replace with a high quality SAE 10W-30
grade engine oil.
!
Every 300 hours of use, have a qualified, certified technician perform thorough maintenance