9
TIE DOWN
Safety Products Division
800-241-1806 • 404-344-0000 • www.tiedown.com
E1847, Rev. 9/24/21
Rescue Winch Installation
The roller cable guide bracket is assembled
and it slides in through the mounting slot and
drops down once in position. Make sure the
the square mounting hole on the right side is
aligned with the bracket and PX3 frame.
Install the Permanent Roller Guide Bracket
It is recommended to use a 1/2” impact wrench for
this part of the installation.
There are two options for installing the permanent
roller guide bracket assembly:
1. Access the nylock nut by working from the top
inside and reaching down.
2. Remove the 8 self tapping screws and the
PX3 metal plate.
Use a 1/2” impact wrench to remove the 3.5”
carriage bolt, washer and nylock nut.
WARNING - Be careful not to come in
contact with the five penetrating spikes.
From the front of the PX3 insert the 3.5” carriage
bolt through the roller bracket and PX3 frame.
Attach 1/2” washer and nut. Use the impact
wrench and tighten the nylock nut.
