13
TIE DOWN
Safety Products Division
800-241-1806 • 404-344-0000 • www.tiedown.com
E1847, Rev. 9/24/21
800-241-1806 • 404-344-0000 • www.tiedown.com
800-241-1806 • 404-344-0000 • www.tiedown.com
800-241-1806 • 404-344-0000 • www.tiedown.com
Wing Nut
(on both sides)
Top Loop
(on Retaining Slide Bar)
Tighten Wing Nut
(on both sides)
800-241-1806 • 404-344-0000 • www.tiedown.com
800-241-1806 • 404-344-0000 • www.tiedown.com
800-241-1806 • 404-344-0000 • www.tiedown.com
Wing Nut
(on both sides)
Top Loop
(on Retaining Slide Bar)
Tighten Wing Nut
(on both sides)
Procedure for Reseting the Penetrator X3 After a Fall
Prior to disengaging the Penetrator X3 after
deployment as the result of an fall incident,
make certain that the rescue procedure has
been successfully completed.
The five penetrating spikes
will be somewhat buried into
the roof after activation.
Follow these steps to reset
the Penetrator X3 Device:
1. Loosen the large wing nuts on both sides of the
PX3 device.
2. Attach the pull hooks to the top loop of the
retaining slide bar. Repeat for opposite side.
3. With a firm pull, pull the handle outward away
from the PX3 cart. The Spike assembly will
slide back to it’s original position.
4. Re-tighten the large wing nuts on both sides.
PX3 Device shown in the engaged position
Do not reuse the Penetrator after incident until fully inspected and any damaged parts have been replaced
and recertification and inspection has been performed. See inspection check list on back cover.
