THUNDER TIGER 6724-F28 PLUS 3.5, Инструкция по эксплуатации и каталог запасных частей

Страница: 6 / 34

5
servo reverse switches
servo trim knobs
a. When turning your system on, ALWAYS turn on the transmitter FIRST.
b. Then, turn on the receiver. When turning off, ALWAYS turn the receiver off FIRST, then the transmitter off.
c. To reverse the functions of servos, use the small, servo reverse switches located on the top of the pistol transmitter. To trim the
servos on pistol transmitter, use the trim knobs(the ST. trims steering, and the TH trims throttle/brake).
Caution! : Do not run flat the battery on your transmitter as you may lose control of the car. For additional details, please
check the transmitter instruction manual.
a.
先開啟發射機電源。
b. 接著開啟接收機電源。電源的關閉則是相反的順序，先關接收機電源，再關發射機電源。
c.
伺服機的正逆轉及微調鈕開關在槍型發射機上側。
注意! 操作前請先確認電池處於充飽電之狀態，以免發生失控之狀況。其他注意事項請參考發射機說明書。
RADIO OPERATION
遙控器操作
4
ON
開
a b c-1 c-2
THE ACE RC COUGAR GP2
熟悉
2.4GHz
電控系統
5
Transmitter Antenna
發射機天線
Battery Level Indicator
發射機電源顯示燈
HI/LO Throttle ATV (Adjustable Travel Volume)
高、低速油門行程調整鈕
Servo reversing switches
正逆轉設定裝置
1
2
3
4
Steering Trim
轉向微調鈕
Throttle Trim
油門微調鈕
Steering D/R (Dual Rates)
轉向大小動調整鈕
External Charging Jack
充電孔
2.4GHz Binding / LED
2.4GHz
校頻配對設定鈕
Steering Wheel
轉向舵輪
Power Switch
電源開關
Throttle Trigger
油門控制板機
Battery Cover
電池蓋
5
6
7
8
8
9
10
1
2
3
4
3
7
5
6
9
10
11
12
13
TRANSMITTER CONTROLS
1. Transmitter Antenna: Built-in antenna, it is not easy broken.
2. Battery Level Indicator: Green / Red LEDs indicate the battery voltage. If the Red LED flashes, please replace the batteries.
3. HI/LO Throttle ATV (Adjustable Travel Volume): Provide the function to let you independently preset the maximum travel of
the throttle servo either side (high / low) of neutral.
4. Servo reversing switches: To reverse the servo's rotation direction at the flip of the switch. The reversing switches are
recessed into the transmitter to prevent accidental operation.
5. Steering Trim: Adjusts the steering in small increments or decrements to run the model straight.
6. Throttle Trim: Adjusts the throttle in small increments or decrements to shift the neutral position.
7. Steering D/R (Dual Rates): Turn this knob left or right to adjust the amount of the steering dual rate. Right to increase dual rate
amount and left to decrease the amount.
8. External Charging Jack: For rechargeable NiCd/NiHM battery pack on the transmitter only.
9. 2.4GHz Binding / LED: The Binding button is located on the top of the 2.4GHz transmitter. For additional details, please refer to
the “Binding” setting procedure (Page 5). LED indicate the RF status. The Red LED means RF funtion is not work.
10. Steering Wheel: Control the steering of the model.
11. Power Switch: Slide to turn the transmitter on or off.
12. Throttle Trigger: Pull or push to control the movement of the model.
13. Battery Cover: Slide cover to install or remove batteries.
1.
發射機天線 ：內建式發射機天線不容易損壞。
2. 發射機電源顯示燈 ：二顆 LED 設計顯示發射機電池殘量，若紅色 LED 燈閃爍時，請更換發射機電池。
3.
高、低速油門行程調整鈕 ：獨立調整高、低速油門行程量功能。
4. 正逆轉設定裝置 ：依實際使用，控制伺服機作動方向。
5.
轉向微調鈕 ：利用此旋鈕，調整設定轉向正確中立點位置。
6. 油門微調鈕 ：利用此旋鈕，調整設定油門正確中立點位置。
7.
轉向大小動調整鈕 ：調整轉向伺服機的行程量。
發射機各部功能簡介
8. 充電孔 ：使用充電式電池時，可利用此充電孔，進行充電工作。
9. 2.4GHz
校頻配對設定鈕
： 2.4GHz
之
BINDING SW
校頻配對設定鈕，為配對發射
/
接收頻率之用。
更多功能設定方式請參考說明書第 5 頁“校頻配對步驟”。
10.
轉向舵輪 ：控制車輛轉向裝置
11. 電源開關 ：發射機電源開關
12.
油門控制板機 ：控制車輛前進或後退的裝置
13. 電池護蓋 ：推移電池護蓋即可取出電池進行更換。
11
12
13