TT-3026L easyTrack Transceiver
Installation Manual
21/
60
4
H
ARDWARE
I
NSTALLATION
The TT-3026L easyTrack is equipped with an 18-pin female
connector and is meant for flat surface mounting, or pole
mounting using an optional adaptor. See section 4.1.1.
Figure 7 shows the minimal easyTrack system configuration,
where the transceiver is pre-configured for tracking.
Remember to short the Remote On/Off pin to GND (refer to
section 4.2.2 for Remote On/Off installation instructions).
Figure 7 Minimum easyTrack system
4.1
I
NSTALLATION OF
TT-3026L
This section describes the physical mounting of the TT-3026L
easyTrack. Refer to sections 4.1.2 and 4.1.3 for guidelines on
choosing the most effective and safest mounting location.
4.1.1
M
OUNTING OPTIONS
The TT-3026L easyTrack transceivers are designed for
mounting on one of 2 optional pole mount adaptors. In
addition the easyTrack transceiver is designed for mounting
on a flat surface using screws.
4.1.1.1
D
RILLED HOLES ON A FLAT SURFACE
Drill the 4 holes (3 for the mounting screws, 1 for
cable access) using the mounting stencil in Appendix
A.
Power Suppy
10,5 -32 V DC
