Read WARNINGS & SAFETY INSTRUCTIONS before operating machine
INSTALLATION
•
Inspect shipment for damages during transit and unpack
WARNING – PLEASE READ SAFETY INSTRUCTIONS FIRST!
•
For portable machines: Connection supply hose to water supply:
-
Important: Use hose with minimum 20 mm inside diameter
-
Required pressurised water supply (not gravity) with minimum of 10 PSI and ~20%
more flow that pump flow rate (litres per minute)
-
Turn on the water supply (open tap fully). Water will fill the
AquaTech
break tank if
fitted
For Skid-mounted units and Trailer-mounted units – ensure tank has enough water and the
water level is at least above the low level float switch otherwise the engine won’t start
•
Unroll the hose fully ensuring there are no kinks in it
•
Trigger gun to expel any air in the system
LAST CHECKS & START:
•
Check all hoses are connected and check for damage or water leaks
•
Check oil level in the pump. The oil sight glass should be HALF full – not more! If oil need
to be topped up, use
SAE 15W40
and top up at the
LubeBuddy
if fitted, otherwise on the
pump itself.
•
Check engine oil level. Use SAE 15W40.
•
Ensure water supply tape (on portable machines) or tank ball valves are wide open
•
For the Industrial Portable frames: Switch on by turning the engine key clockwise, and then
further to the START position. Engine should fire up.
•
For Rental and Mine spec portables, Skid Mounts and Trailer mounts:
Ensure that the Emergency Stop is not engaged. Torn clockwise to disengage.
Switch on by turning the ON/OFF switch to the ON position or press the START button.
The machine will fire up, start pumping and the RED & ORANGE indicator light will be off.
3