THORLABS Vytran LFS4100, Руководство пользователя

Страница: 32 / 44

LFS4100 Chapter 6: Fusion Splicing
Rev B, July 24, 2018 Page 29
6.6. System Malfunction
If the system detects a critical problem during any operation, the Failure window will be shown and request input
from the operator for further operation.
Abort:
This button ends the current one button
process.
Retry:
This button runs the failed process a
second time. If it fails again, the one button
splice will end.
Continue:
This button skips the failed
process and executes the next process in the
process list.
Reset:
This buttons runs the reset macro. On
completion, the user can choose to abort, retry,
or continue.
6.7. Initialization and Shutdown
When the LFS4100 is turned on, it is necessary to press the Initialization button in order for the
software to establish communication with the system. The initialization button is pictured to the
left. Before initialization takes place, most of the buttons on the GUI will appear grey, and the
status bar light will be dull red. The LFS4100 must be on for initialization to succeed.
Shutting down the LFS4100 requires no special sequence. Switch the LFS4100 off, turn off the vacuum pump,
external supply, and argon supply, close the GUI, and then shut off the PC.
6.8. Storage and Transportation
When packaging the splicer for storage or transportation, the following precautions are necessary:

Ensure that the lens assembly is at the home position.

Attach the transport block to secure the lens in its home position. This is important to ensure that the lens
system does not move during shipment.

Disconnect all gas and electrical connections.

Make sure that the foam is positioned properly in the original packing box.

Lower the LFS4100 system carefully into the box.

Position the foam insert over the top of the LFS4100 and then carefully close the top of the case.

DO NOT PACK ANY OTHER ITEM WITH THE LFS4100. SEVERE DAMAGE WILL BE CAUSED TO
THE SYSTEM IF THOSE ITEMS MOVE IN TRANSIT.