THORLABS S4FC Series, Руководство пользователя

Страница: 14 / 27

S4FC Series Fiber Coupled Laser Source Chapter 5: Operation
Page 12 TTN051387-D02
Note: Changing any of the settings below allows the user to make immediate changes to the controller.
Figure 6 The S4FC Setting Control Windows
Friendly Name
Allows the user to change
the name of the device up
to 24 characters long
Panel Adjustment Range
Settings
Sets the enable start point
See section 5.7, page 9
Enable Blinking
Auto Lock
See section 5.4, page 8
Start from Last Saved
See section 5.7, page 9
Adjust Current
See section 5.7, page 9
Display Intensity
Adjusts to brightness of the
display from 0 (min) to 15
(max); note the intensity at
0 will not be off, just dim.
Output Limit
Allows the user to limit the
output by setting lower
current than the default
max current value
Enable
Enables the LD and sets
the output power
See section 5.7, page 9
Set Point
Indicates or sets the
temperature set point
between 20 and 30 °C
Interlock Active
This box is an indicator
only. When checked the
interlock is active/been
tripped.
Count Down
Indicates seconds until LD
is enabled
LD mW
Indicates or sets the mW output level. This value may differ
than the display on the unit due to the accuracy of the
internal measurement. The value on the LCD will always be
the calibrated output power, not this setting value.
Lock
Indicates or sets the
settings lock state
LD Power Slider
Slides for coarse LD
output adjustments
Set Point
Indicator only. Box is
checked when
temperature is set.
Ambient
Indicates, only, the
ambient temperature (at
the front of the display)
Actual
Indicates, only, the actual
LD temperature