THORLABS EDU-OMC1, Руководство пользователя

Страница: 35 / 60

Optical Microscopy Course Kit Chapter 5: Setup and Adjustment
Rev C, October 1, 2020 Page 31
2. Use two 8-32 (M4) cap screws, 1/2" (12 mm) long, and screw the MS1S stage adapter to the MS1S-SP
(MS1S/M) stage as shown in the image. The dowel pins are tight fit and will make a precise orthogonal
alignment. In order to avoid placing strain on (and damaging) the delicate ball-bearings,
hold the top
portion of the MS1S-SP (MS1S/M) stage while securing the adapter to it.
a. IMPORTANT : The adapter plate lip (see figure) should face away from the stage
micrometer.
3. Attach the XYF1 (XYF1/M) slide holder stage with an 8-32 (M4) cap screw, 3/4" (20 mm) long, to the
adapter through the central countersunk hole.
4. Screw the AP8E25E (AP6M4M) adapter screw [1/4"-20 to 8-32 (M6 to M4)] into the bottom part of the
stage. In this case, to avoid damage to the ball-bearings, avoid strain on the stage during the attachment
by
holding the bottom part of the stage while tightening.
Dowel Pins
Alignment Lip
Central
Countersunk
Hole