THOR Salamander GL163-N, Инструкция по установке и эксплуатации, Страница: 7 / 17

6
Installation (Continued)
NOTE: Do not obstruct or block the appliances flue. Never directly connect a ventilation
system to the appliance flue outlet.
Clearances
NOTE:
Only non-combustible materials can be used in close proximity to this appliance.
Combustible Surface Non Combustible Surface
Left / Right Hand Side
Rear
Top Clearance to:
- Extraction Hood
- Grease Arresting Filter**
- Ceiling***
100mm
50mm
25mm*
30mm
200mm
400mm
750mm
* We recommend allowing a clearance of 100 mm on either side of the
appliance to allow access to the side panels for servicing purposes.
** Using the wall mounting accessories provided with this appliance.
*** Top clearances can be reduced where local fire protection system is provided,
if allowed by the local regulations.
Wall Mounting (To Non-Combustible Wall Only)
1. Fix the wall mounting bracket to the wall with six screws, in such a position that the top of
the bracket is level and at least 945 mm (38”) above any surface beneath the unit. This will
ensure that the bottom of the Salamander is at least 600 mm (24”) above any surface.
2. Fit the two black plastic spacers to the top rear corners of the unit. Leave them unscrewed by
approximately 5 mm.
3. Fit the two adjusting screws / bolts into the nut inserts at the bottom rear corners of the unit.
These should protrude approximately 30 mm from the rear of the Salamander.
4. Lift the Salamander onto the wall bracket, lining up the black plastic spacers on the
salamander with the mounting notches in the bracket.
5. Lower the Salamander onto the mounting bracket.
6. Tighten the black spacers securely and adjust the levelling screws / bolts to ensure that the
unit is level.
Gas Connection
NOTE: ALL GAS FITTING MUST ONLY BE CARRIED OUT BY A QUALIFIED SERVICE
PERSON.
1. Thor salamanders do not require an electrical connection, as they function totally on the gas
supply only.
2. It is essential that the gas supply is correct for the salamander to be installed and that
adequate supply pressure and volume are available. The following checks should therefore be
made before installation:-
a. Gas Type the appliance has been supplied for is shown on a coloured stickers located
above the gas connection and next to the rating plate. Check that this is correct for the
gas supply the appliance is being installed for. The gas conversion procedure is detailed
in this manual.