THOR Salamander GL163-N, Инструкция по установке и эксплуатации, Страница: 10 / 17

9
Operation
Operation Guide
CAUTION:
•
THIS APPLIANCE IS FOR PROFESSIONAL USE AND IS ONLY TO BE USED BY QUALIFIED PEOPLE.
•
ONLY QUALIFIED SERVICE PERSONS ARE TO CARRY OUT INSTALLATION, SERVICING OR GAS CONVERSION
OPERATIONS.
•
COMPONENTS HAVING ADJUSTMENTS PROTECTED (E.G. PAINT SEALED) BY THE MANUFACTURER SHOULD NOT
BE ADJUSTED BY THE USER/OPERATOR.
1. Thor Gas Salamanders have been designed to provide simplicity of operation and 100% safety
protection.
2. Improper operation is therefore almost impossible, however bad operation practices can reduce the
life of the gas salamander and produce a poor quality product. To use this appliance correctly
please read the following sections carefully:-
z
Lighting the Main Burners.
z
Racking System
z
Cooking Recommendations
Description of Controls
The salamander has individual heat controls for the left and right sides. Select the desired heat level and allow
a few minutes for clear the air in the pipe during initial use.
• Thor salamanders provide two independently controlled heat zones.
•
The left hand and right hand gas control knobs operate the left side and right side burners respectively,
independently of each other.
•
Each burner is provided with flame failure protection.
Lighting the Main Burners
1. Select the burner required, depress and turn the corresponding gas control knob anti-clockwise to
'HIGH' flame position.
2. With the gas control knob depressed, manually light the burner. (It will take about 1 minute to clear
the air in pipe during initial use).
3. Release the gas control knob after approximately 10-20 seconds after lighting the burner.