THOR Salamander GL163-N, Инструкция по установке и эксплуатации, Страница: 13 / 17

12
Gas Conversion Procedure
NOTE:
• These conversions should only be carried out by qualified persons. All connections must be
checked for leaks before re-commissioning the appliance.
• For all the following conversion instructions, the side panels have to be removed (Remove the
two screws at the bottom of each side panel).
• All conversion details apply to both L/Hand and R/Hand burners.
• For all relevant gas specifications refer to the table at the end of this section.
Main Burner Injectors
1. Ensure that the gas supply has been turned 'Off'.
2. Unscrew the main burner injectors (½” A/F).
3. Determine the correct injector sizes for the corresponding gas type from the rating plate affixed to the
right hand side panel front bottom corner.
4. Replace with the correct size injectors.
Low Fire Adjustment
1. Remove the gas control knobs from the front of the unit.
2. Remove the 2 front control panels by removing the two screws (per panel) located at the bottom of each
panel.
3. Set the burner low fire adjustment. The low fire screw on the gas control valve should be screwed fully in,
then unscrewed by the measurement shown in the ‘Gas Specifications’ table.
Commissioning
Before leaving the converted installation;
1. Check all gas connections for leakages using soapy water or other gas detecting equipment.
2. Check the following functions in accordance with the operating instructions specified in the ‘Operation’
section of this manual.
• Light the Main Burners.
• Check the Low Fire burner operation.
• Check the High Fire burner operation.
• Ensure all controls operate correctly.
NOTE:
If for some reason it is not possible to get the appliance to operate correctly, shut off the gas
supply and contact the supplier of this unit.
WARNING: DO NOT USE A NAKED FLAME TO CHECK FOR GAS
Replacement Parts
IMPORTANT:
Only genuine authorized replacement parts should be used for the servicing and repair of this appliance.
The instructions supplied with the parts should be followed when replacing components.
For further information and servicing instructions, contact your nearest authorized service branch.
When ordering replacement parts, please quote the part number and the description listing below. If the
part required is not listed below, request the part by description and quote model number and serial number
which is shown on the rating plate.
CAUTION: Please replace the corresponding warning label that shows the gas
type operated when the qualified person will convert to another gas in order not
to cause death or injury or damage.