15
B.
Lighting the Pilot Burner of an Open Burner
Flame Failure Protection is incorporated for each burner by way of a thermo-electric system
which will shut off the gas supply to that burner in the event that the pilot burner flame goes
out, so that un-burnt gas is not expelled to the surroundings.
has been lit, hold the knob depressed for 10-20 seconds after lighting the pilot burner. This is
to give ample time to heat up the thermocouple, and allow gas to flow into the gas valve.
4.
Release the knob after 10-20 seconds. The pilot burner should stay lit, if not, repeat Steps (1
to 3 above).
5.
If pilot burner was extinguished during normal operation, wait for 5 minutes before lighting it
up again.
C.
Lighting the Main Burner of Open Burner
1.
Select the burner to be lighted.
2.
Full flame can now be achieved by depressing the knob a little and turning it counter-
clockwise to the first stop, “HIGH” flame position.
3.
To achieve simmer control, depress the knob a little and turn it further counter-clockwise to
the second stop “LOW” flame position. Note that the gas control knob can be rotated between
“HIGH” and “LOW” flame to achieve your desired flame height.
D.
Turning “OFF” the Main Burner of Open Burner
1.
Select the burner to be turned “OFF”.
2.
To turn off the main burner, but keep the pilot burner lighted, rotate the gas control knob
clockwise to “PILOT” position. Notice that the main burner will extinguish and the pilot will
remain lit.
3.
It is recommended to turn “OFF” the main burners during idle periods, but let the pilot stay lit.
E.
Turning “OFF” the Pilot Burner of an Open Burner
1.
Select the Pilot Burner to be turned “OFF”.
2.
To turn OFF the pilot burner, rotate the gas control knob clockwise to “
l
” position. Notice
that the pilot burner will extinguish.
The open burners of this Gas Oven
are fitted with individual standing pilots, which allows the
main burners to be turned ON or OFF without the need to manually re-light the burner each
time that it is turned OFF, as the burner will be automatically lit by the pilot burner.
1.
Select the pilot to be lighted.
2.
Depress the gas control knob and turn it counter-clockwise to “PILOT”.
3.
While the knob is depressed, light the pilot burner manually with a matchstick. Once the pilot
