Trouble shooting
18
PILOT TROUBLE SHOOTING
CHECKING & CLEANING OF THE ODS INJECTOR:
1. Visually check the orifice of the pilot injector
if clogged, damaged or blocked. If it cannot
be checked visually, try to blow air in the
injector and check if there is air coming out
of the orifice.
2. If the orifice is blocked or clogged, use an air
blow to remove the clogging. Never pinch
the orifice with a pin as this could damage
the orifice.
3. If the clogging cannot be removed from the
orifice by air blow, replace the injector with
a new one. Remember to check the size of
the orifice and replace with the same size.
4. Follow the ODS injector removal procedure.
FLAME DEVICE SYSTEM
PILOT
BURNER
THERMO
COUPLE
IGNITER
ODS
INJECTOR
INSIDE PILOT
NOTE:
When you order a Flame Device System
(FDS), the ODS injector is not included. The ODS
injector can be ordered separately.
PILOT
TUBE
FLAME DEVICE SYSTEM ODS INJECTOR REMOVAL:
1. Shutdown the fryer. Follow the complete
shutdown procedure.
2. Shut-off the main isolation valve and follow
the lock-out/tag-out procedure.
3. Let the fryer cool down for a few minutes
before starting your work.
4. Remove the mounting screw of the FDS
Assembly, then remove the FDS Assembly.
5. Disconnect the pilot tube from the FDS. Use
12mm spanner.
6. Pull-out the pilot tube, then remove the ODS
injector.
7. Clean or replace the ODS injector if necessary.
8. Make sure to check for gas leak, using soap &
water, after part installation.
Remove the mounting screw of the FDS
Remove the ODS injector
MOUNTING
SCREW OF FDS
ODS
INJECTOR
