Thor Motor Coach Class C, Руководство пользователя

Страница: 59 / 97

Thor MoTor CoaCh
ELECTrICaL SYSTEMS
6.0
Note: When operating 12 Volt equipment from battery, reduce equipment in use to
conserve battery. Gradual dimming of lights, and slowing of motors indicates low
battery voltage.
Battery Disconnect Switch
The battery disconnect switch allows you to easily disconnect the auxiliary batteries from electrical circuits,
preventing unwanted discharge during extended non-use. The switch(s) is/are mounted on a panel near the
entrance door.
There are two main uses of the battery disconnect:
1. Prevent unwanted discharging of batteries during extended periods of storage.
2. Prevent shorts or fire hazard while working on the 12 Volt electrical system.
When activating, place the switch for the desired battery system in the ON position. This battery system will
now be operational. The disconnect switch must be in the ON position while plugged into shoreline power to
charge the battery(s). Place the switch in the OFF position to disconnect 12 Volt circuits.
Note:
If 12 Volt functions are not working, be sure to check that the battery disconnect
switch has been placed in the ON position.
Battery Charging
aLWaYS WEar SPLaSh ProoF SaFETY GLaSSES WhEN WorKING WITh
BaTTErIES.
The converter/inverter also operates as a battery charger when it is connected to a 120V power source. If the
battery is below its full charge, the converter/inverter charger will begin operation at a rate that reflects the level
of discharge. When the battery is again fully charged, the converter charger drops its charging level back to a
maintenance level to keep the battery fully charged.
If for any reason you charge a battery with a source outside the motor home, make sure to follow the rules
of battery maintenance and safety outlined in this section. Also observe these additional safety precautions
related to battery charging:
1. Disconnect the battery from the motor home.
2. Check electrolyte before charging. Be sure each cell is properly filled with distilled water.
3. Make sure to use care when connecting and disconnecting the cables from chargers. A poor
connection can cause an electrical arc, which can result in an explosion.
4. Remove the battery vent caps before charging, and make sure that the electrolyte does not
splash out as a result of charging too quickly.
5. Check literature supplied by battery manufacturer, and follow warnings or cautions outlined.