P10
Quick GuiDe To usinG Your receiver
Beeper
:
Select
On
for an audible indication of signal reception.
Off
turns the beeper off.
Channel No.
:
Select a channel that is known to carry a broadcast in your
region. The
Signal Strength
and
Signal Quality
bars give a visual
indication of the reception. Adjust your antenna to obtain
maximum signal strength and quality.
When all settings have been made, press
ok
to start scanning.
The receiver will search for all available channels now. Once scanning is finished, the
receiver switches to viewing mode.
TiP:
If the Welcome menu does not appear after switching on the
receiver the first time, reset the receiver to factory settings by
pressing the
Menu
button and selecting Load Factory Setting
in the submenu Tools.
(DefAuLT Pin: 1234)
.
5.0 Quick GuiDe To usinG Your receiver
We at THOMSON understand that you can’t wait to enjoy your new high definition
digital terrestrial receiver. The following quick guide will make you familiar with the
basic operation of this device. We do, however, advice you to read the full manual to
get the best performance from your receiver.
To turn your receiver ON or to Standby, use the
q
button on the remote control.
Choose the desired channel with the
pq
buttons. Alternatively, you can digit the
channel number with the
0~9
buttons on the remote control or press
ok
in viewing
mode to display the channel list. The volume can be adjusted with the
tu
buttons.
6.0 oPerATion
Your new receiver is equipped with several features to make watching TV a true
pleasure. This paragraph describes these features. Please also read chapter
7.0
to get
familiar with the menu of your receiver.
6.1 changing channels
Following ways are possible for changing channels with your new receiver:
Via direct access using the
0~9
buttons.
Via the channel list through
ok
and the
PG+/PG-
buttons.
Via the
pq
buttons.
6.1.1 Direct access via 0~9 buttons
To gain direct access to a certain channel, simply input its number with the
0~9
buttons on the remote control. Channel numbers can be up to four digits long.
Entering a number with less than four digits is possible. Just wait a few seconds
