14
* Only available if more than one satellite has been setup.
NOTE:
Network Data/NIT Table (Network Identification Table): This function
allows you to search the NIT data of the corresponding satellite to receive
newly released channels. Please consider that in contrast to Astra 19.2
and HotBird 13.0 some satellites do not have this database respectively
can only support it partly. If you have any questions, please contact your
dealer or the service.
NOTE:
If you want to add or edit parameters for a transponder, we
recommend verifying it by consulting websites like: www.lyngsat.com;
www.kingsofsat.net or you can refer to professional journals.
7.1.4 1 Edit, add or delete transponders
In this submenu, you can edit transponders. Use
pq
to navigate.
Frequency
:
Use the
0~9
buttons to enter the desired/changed frequency.
Symbol Rate
: Use the
0~9
buttons to enter the required symbol rate.
Polarization
:
Use the
t
u
buttons to change the polarization.
Select
pq
Save
to accept or
Cancel
to discard the changes.
If you have selected a specific transponder from the list and want to delete it, use the
YELLOW
key
and confirm the message with
OK
.
7.1.5 Factory Reset
The factory reset will set the receiver back to the default settings. All saved channels and settings will
be lost!
To reset the receiver, enter your PIN-Code(
DEFAULT
PIN-CODE
:
0000
). Use
t
u
to select
OK
to
perform the reset or
Cancel
to return to the menu. After the factory reset the receiver will start within
the
First Time Installation
.
WARNING:
A factory reset will permanently delete all your personal settings, channels
and timers. Please consider this before you perform a factory reset.
7.2 Channels
Press
MENU
and use
t
u
to select the
Channels
menu. The following sub-menus are available:
TV
Channel Manager
,
Radio Channel Manager
,
Electronic Programme Guide
and
Parental Control
.
7.2.1 TV Channel Manager
This menu allows you to customize your channel list or create favourite lists. To perform the desired
action, proceed as described below.
On the upper left, you can see the preview of the currently selected channel. Below you can find
the selection of the various functions as well as
FAV
for creating favourite lists. In the middle is the
empty list where selected channels will be displayed. On the right, in the
Program List
you will see the
channels listed as in the standard channel list (depending on which one was selected during the First
Time Installation). Use
pq
to select a desired function and then
u
to go to
Program List
(except
when selecting
FAV
, see below). Then you will see that the selected option is dark grey. You can use
P+/P-
to scroll through lists.
!
and
VOL+/VOL-
are also available in this mode.
If you are in the
Program List
(right), you can select channels to be locked, deleted or moved by
using
OK
. These are listed in the centre under
Selected
. In this stage the receiver will switch to the
selected channel automatically which should make the allocation easier for you. If you have marked
a channel by mistake, move to the centre and press
OK
on the channel and the selection will be
cancelled.
When using the
Lock
function, the selected channels are marked with the
after saving. Locked
channels are locked in all channel lists, the PIN-Code must be entered for viewing (
DEFAULT PIN-
CODE: 0000
).