En
gli
sh
11
NOTE:
If you configure an HDMI resolution which isn't supported by your TV,
there is no problem because if you press no button, the receiver will
automatically switch back to the last used resolution after ~ 10 seconds.
However, if you can see the displayed message, then confirm the selected
resolution by pressing
OK
.
6.7 EPG (Electronic Programme Guide)
The Electronic Programme Guide (EPG) provides an information overview on the current television
programme. The information is provided by the respective broadcaster and may not be available for
all channels.
Therein you will find program information and overviews and you can also program a timer (for
viewing or with your VCR).
To open, press the
EPG
button in TV mode. By default, the
Grid EPG
is set, which gives you a better
overview of the current program on several different channels. On the left you will see the channel
list, on the right the events preview with the event information for the next hours. The corresponding
short information about the selected event is displayed in the upper right of the screen with the
start and end of the event. Use the
pq
buttons to select the desired channel, then press
OK
to
switch to the channel and load its information. If you press
OK
again on you will directly switch to TV
mode. Use
u
to highlight a particular event of the selected channel. Press
INFO
to display detailed
information and press to close it again. Press the
BLUE
button to go 6 hours forwards and press
the
YELLOW
button to go 6h backwards (not further than to current time). To go directly to the
current time use the
GREEN
button. The
RED
button allows you to book a timer for a selected event
and with
LIST
you can open the timer list.
For details on editing timers, see chapter
7.3.4 Timer
, the function is identical.
Use the
EPG
button to switch to
Single EPG
.
Single EPG
In this form of the EPG, you always see the list of information for the selected channel on the right
where you can use
pq
to select an event. The corresponding event description is located in the
lower area. To go to the next or previous day, use the
BLUE
and
YELLOW
buttons, to return to the
current contents use the
GREEN
button. The remaining functions stay as described above. To switch
to the
Grid EPG
use the
EPG
button and to leave the menu use or press
OK
for a 2nd time on the
selected channel.
The detailed description of the timer functions can be found in chapter
7.3.4 Timer
.
NOTE:
Availability of EPG data depends on broadcast and can be displayed for up
to 7 days. If you are opening the EPG just after the receiver was switched
on or changed to another transponder we recommend to wait for a short
moment in order to collect the data.
7.0 MAIN MENU
Press
MENU
in viewing mode to display the main menu. All important settings and features of your
receiver can be operated from there. It consists of the following sub-menus:
Installation
,
Channels
,
Settings
,
Multimedia
,
Update
and
CA Menu
.
Use
t
u
to select a sub-menu and
pq
to choose an option. Press
OK
to open the chosen
submenu.
7.1 Installation
Press
MENU
and select
Installation
with
t
u
. The following sub-menus are available:
Antenna
Setup
,
Motor Setting
,
Channel Search
and
Factory Reset
.