THOMSON SpeedTouch 620, Руководство оператора

Страница: 100 / 216

Chapter 8
SpeedTouch™ Remote Access
E-DOC-CTC-20051017-0155 v1.0
90
Hyper-NAT Refinements
The SpeedTouch™ features a powerful Hyper-NAT engine allowing the local hosts
to share a single (remotely negotiated) public IP address.
In case Hyper-NAT is enabled on the WAN interface that will be used for remote
management, and a static mapping has been made to allow remote hosts to open a
Telnet session to a host residing on your local network, you must make sure that
Telnet access to the SpeedTouch™ CLI is still possible.
The default port for the Telnet server is set to 23. This can be changed by executing
the following command:
The command above will change the Telnet server port of the SpeedTouch™ from
port 23 (default) to port 50.
For more information on Hyper-NAT, see the SpeedTouch™ Hyper-NAT
Configuration Guide.
=> :service system modify name= TELNET state=enabled port=50
=>
=> :service system list name=TELNET expand=enabled
Idx Name Protocol SrcPort DstPort Group
-----------------------------------------------------------------------
1 TELNET tcp
50
Description................ Virtual Terminal
Properties................. server
Attributes................. state port aclip aclif aclifgroup map log
User Managed Attributes.... state port aclip aclif aclifgroup map log
Attribute Values :
State...................... enabled
Port.......................
50
Ip Access List............. any
Interface Access List...... any
Interface Group Access List lan wan
Map List...................
50
Logging.................... disabled
=>
!
NAT-refinements for SpeedTouch™ services should never be made in the
NAT configuration menu, but always in System Services.