7. Maintenance
7-3
CSKR
7-3
Daily inspection
z
Before operating the product, visually check any exterior damage or stain.
z
Check whether abnormal noise or vibration occurs during operation. If abnormal noise
or vibration occurs, immediately stop the machine and inspect the state of the product.
Check insufficient lubrication or loosening a mounting bolt that can cause abnormal noise or
vibration.
7-4
Periodical inspection
z
Perform more detailed inspection approximately once every 3 to 6 months.
•
Check the lubrication state, and clean the product and replenish grease.
•
Inspect whether or not each mounting bolt is loose, if any of them has loosened, retighten it.
•
For the suction joint, check the following and replace it as needed:
1) Scratch, dent, wear, and corrosion
2) Air leaks
3) Twist, crush, or distortion of a tube
4) Hardening, deterioration, or softness of a tube
•
Inspect a sealing sheet as follows:
(1) Visually check abnormal wear, scratches, or cracks on the surface of the sealing
sheet.
If you find any abnormalities, replace the sealing sheet.
For the replacement procedure, see “Replacement of sealing sheet procedure.”
(2) Visually check any stains on the sealing sheet.
If you find it extremely dirty, move the slider to the end of each stroke and clean the surface
with a clean waste cloth soaked with ethanol.
Be careful not to strongly press the sealing sheet in cleaning.
7. Maintenance
www.thk.ru
тел. +7(499) 703-39-86
