RV Installation Instructions continue on Page 5.
Installation
RV Model
1. Install the two closet bolts in closet flange.
. While holding bolt up so the head touches underside
of closet flange, install one nut on each bolt and screw
nuts down until they
touch top of gauge. If
gauge is misplaced,
bottom surface of
nuts should be 1.4
in. (.4 cm) above
floor.
5. Place unit on closet flange and locate position for plastic
locator disc by tracing around one of the front legs. Drill
5/32” dia. hole in floor and fasten disc to floor with flat
sides oriented as shown. Use #10 screw provided.
Important: This disc prevents toilet from moving on
floor.
6. Lower toilet onto closet flange until nuts on closet bolts
go through rectangular holes in metal brackets, seal rests
on closet flange, and leg locates over locating disc.
4. Make sure white
fork-shaped
slides are in
forward posi-
tion.
3. Turn the toilet upside-down and install closet flange seal
on Slide-EZ Valve with flat side against toilet.
Electrical Hookup
RV and Marine Models
Connect your 1-Volt or 4-Volt model Electra Magic
directly to the appropriate D.C. source as a separate circuit.
Use minimum size #14 gauge wire. (Black wire to positive
[hot], white to negative [ground].)
Important
– Be sure polarity of power supply has been
properly determined and correctly connected to lead wires
before operating.
Enfocus Software - Customer Support