8
Disassembly
RV and Marine Models
1. Fuse Replacement
A. Remove two () #09 cover mounting screws and
#094 Motor Cover Assembly.
B. The fuse is now readily accessible for checking or
changing.
2. Switch Removal
A. Disconnect lead wires from power source.
B. Remove two () #09 cover mounting screws and
#094 Motor Cover Assembly.
C. Remove switch retaining nut and remove wires from
switch terminals.
3. Slide-EZ Valve Removal
A. Disconnect lead wires from power source.
B. Completely evacuate unit.
Note: If you have a #24320 extension handle unit, cotter pin
and extension handle must be removed at this point.
C. Remove two () #0915 moulding mounting screws and
remove two () base mouldings
(See Pg. 6)
.
D. Remove slides by catching tabs with a hooked instrument
and pulling forward
(Pg. 5)
.
E. Lift toilet from closet flange and invert unit.
F.
Remove four (4) #08737 screws; remove valve (Pg. 5)
.
4. Sump Removal
A. Disconnect lead wires from power source.
B. Completely evacuate unit.
C. Remove two () #0915 moulding mounting screws and
remove two () base mouldings
(Pg. 6)
.
D. Remove slides by catching tabs with a hooked instrument
and pulling forward
(Pg. 5)
.
E. Remove flexible hose from sump and invert unit.
F.
Remove four (4) #01663 screws; remove sump (Pg. 7)
.
5. Pump Removal
A. Complete steps A and B above.
B. Completely evacuate unit.
C. Remove cover and bowl assembly screws two (2) #03979
in rear from top side and two () #094 in front from
bottom side and remove #091 cover and bowl assembly
(Pg. 6)
.
D. Remove four (4) #095 pump mounting screws.
E. Disconnect #0946 inlet tube from pump outlet.
F. Remove #0950 pump assembly
(Pg. 6)
.
Enfocus Software - Customer Support