Operation Panel Status
BA_TT5-L_GB_V(0).DOCX
page 32
Ribbon Error
2 x 3 beeps
No ribbon is installed and the
printer displays an error.
Make sure that the printer
is set to direct thermal
printing mode.
The ribbon is finished or the
label supply hub is not
moving.
Replace the ribbon roll.
Media Error
2 x 2 beeps
No paper is detected.
Make sure that the label
sensor is positioned
correctly.
If the sensor still does not
detect the paper, run the
auto- detection function
again
Paper is finished.
Replace the label roll.
Printer feed problem.
Possible reasons: the
printer medium has
become trapped around
the rubber roll; the sensor
cannot detect a gap or
black mark between the
labels; there is no paper.
Please reset the sensor.
File Error
2 x 2 beeps
The memory is full. The
printer prints the message
« File System full ».
Delete unnecessary data
or install additional
memory.
Unable to find file. The
printer prints the message
« File not found »
Use the « ~X4 »
command to print all files.
Then check whether the
files exist and whether the
names are correct.
