Thermoscreens C series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 7 / 16

4001160-6 UK Page 7 of 16
Fitting/Connecting the Remote Control
The Ecopower Plus controller uses extra low voltage to communicate via the RJ control
cable supplied. The controller should be located in a suitable place for easy access, it
can be fixed to the wall via various fixing slots
provided in the back case or onto an electrical
switch box (not provided). To mount controller
onto an existing switch box, feed one end of the
control cable through the switch box (see insert).
Using a screwdriver undo screw mounted on
the top of the controller case. Pull the front case
slightly forwards and lift the back case away.
Feed and secure the RJ control cable through
one of the openings in the back case and
secure back case to switch box using 2 x M3.5
mounting screws (not provided).
With the cable RJ plug locking clip lying nearest
to controller PCB, connect the RJ plug to the RJ
socket on the board.
Note:
For controller DIP switch options refer to
Ecopower Plus Remote Control Operation and
DIP Switch Settings
.
Refit the controller front case to the back case.
The air curtain end of the control cable should be
connected to one RJ socket fitted either on the
top panel for NT or the Ecopower motherboard
inside a recessed air curtain. Ensure the control
cable is safely secured.
Multiple Installation (Ecopower only)
To Master/Slave two or more air curtains together a suitable RJ lead should be
connected from the Master to the Slave unit. Thermoscreens 3.0m RJ extension leads
must be ordered separately. Additional air curtains, up to a maximum of eight units,
may be connected as indicated below. For Master/Slave configuration an independent
mains supply must be supplied to each air curtain.