Thermoscreens C series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 3 / 16

4001160-6 UK Page 3 of 16
INSTALLATION OF YOUR HORIZONTAL APPLICATION C AIR-CURTAIN
The C air curtain has been designed for surface mounting only inside of
the building.
Location
Ensure that the unit is mounted within its height
specification of 1.8m minimum to 3.0m maximum
(from floor level to the underside of the unit) and
that it is situated as close to the door as possible
with a 100mm air gap above the air curtain (see
adjacent figure). In some cases it may not be
possible to mount the air curtain as close to the
door as possible as the air stream may strike the
top edge of the doorway, a structural beam or a
door opening device etc, therefore this will have
to be taken into account when locating the unit.
Wall Fixing
Bolt the wall brackets to the rear face of the unit
as shown in the adjacent figure (using the bolts
supplied). Before fitting the unit to the wall obtain
suitable fixing bolts, taking into account wall type
and unit weight (see table 1).
Step 1.
Refer to Figure 1 for mounting details
and drill the wall accordingly.
Step 2.
Screw in the top bolts leaving a small
gap between the head and the wall; lower the
unit onto the bolts via key hole slots in the top of
the wall brackets and then screw in the bottom
bolts.
Step 3
. Ensure all fixing bolts are tightened to
stop the unit being lifted off the wall.
Ceiling Suspension
6mm threaded inserts are provided in the top
face of the casing (4 x M6 on the 1m and 6 x M6
on the 1.5/2m models, for dimensions see Figure
1) allowing the unit to be suspended on threaded
rod (threaded rod is not provided). Ensure each
of the threaded rods are secured on to a suitable
structure that can support the weight of the unit
(for unit weights see Table 1)*. When fitting the
threaded rod ensure that it does not interfere with
internal components. Fit locking nuts (not
supplied) and ensure they are engaged by a
minimum of 20mm to stop the threaded rod
rotating and coming away from the casing.
*Please note it is the sole responsibility of the installer to ensure that the fixing points
and bolts used are suitable for the air curtain being installed.