thermopatch.com
14
TO sET UP rEsETAbLE COUNTEr:
press - > reset counter > press ok (or
Set up
to cancel)
TO sET UP PErmANENT COUNTEr:
: not modifiable
TO sET UP PrE-hEATINg:
press ok, then + to modify oN/off
Note: pre-heating time will be able only if pre-heating
parameter is oN.
TO sET UP sTANDby:
: press
to modify > + activate (oN) > ok > + to
modify standby temperature, ok > + to modify start standby
time > ok > + to modify wake-up time
coDe : press ok to enter a code, + for next digit, ok to
confirm and swap to next.
100 : time setting :
to enter in, + to modify, OK to confirm
300 :
Δ
> ok to enter in offset temperature setting >
to
modify offset > +/- to change value.
> ok to enter in AlArm parameters at end cycle >
to
modify > +/- to change value.
°c/°f > ok to modify temperature UNiT > + to modify > ok
to confirm > Set up > Set up to exit.
Adr. moDbUS : > ok to see communication port (switch on
board).
DETAIL Of ThE fULL AUTO OPTION :
if you have this option, you can change the cycle of the
machine.
• Normal mode : After you push the pedal, the press platen
moves to the other plate and press.
• one plate mode : After you push the pedal, the press
platen moves to the other plate, press and come back to
its starting plate.
• Automatic mode : After you push the pedal, the press
platen moves to the other plate and starts the heat
sealing cycle. At the end of the « sealing timer » it
automaticaly switches platens and heat seals again. This
will continue until you push the pedal or the touch ok/
STop, which will end the automatic cycle.
choice of functioning mode :
push Set up --> (2 plATeS) --> ok -->(
) --> +-->ok
: push “+” , to activate « yeS » ,or deactivate « No » ,
the AUTomATiQUe mode. push on ok to validate your
choice and pass to the next parameter.
1p : push “+” , to activate « yeS » ,or deactivate « No » , the
oNe plATe mode. push on ok to validate your choice.
