Thermopatch Auto Maxi NL-33, Руководство пользователя

Страница: 21 / 22

thermopatch.com
21
Symptoms Possible breakdowns Repairs
The machine will
not switch on
• The plug is not in.
• The switch is not connected.
• The general fuse is out of
order.
• The card fuse is out of
order.
• The display unit is faulty.
• Put the plug into the wall socket.
• Switch the On - Off switch to “ON”(I).
• It is situated in a casing next to the
power cable plug. To access it, pull
the power cable out, with the tip of a
screwdriver lift the fuse casing. you will
find in the square tube a replacement
fuse to put instead of the one in the clip.
• It is situated at the bottom left of the
card (1A).
• Check if the flat cable is properly
connected otherwise the display unit is
out of order.
The plate will not
heat
• The resistors are defective.
• Card problem.
• Temperature value too low.
• Check the connections and the state
of the electric wiring. To remove the
heating plate, get in touch with your
supplier.
• See messages displayed on the screen
and refer to the card manual.
• To modify this value, see chapter V.
The plate
overheats
• Sensor or card problem. • See messages displayed on the LCD
screen and refer to the card manual.
get in touch with your supplier.
The timer will not
count down
• The detector placed on
a jack is not activated or
defective.
• Card problem.
• Check its connections.
• See messages displayed on the screen
and refer to the card manual.
The plate will not
go down
• The push buttons will not
work.
• Leak on the jack.
• The electrical distributor is
faulty.
• The compressed air
pressure is not enough.
• Check their connections.
• Check the joints and all the connections.
get in touch with your supplier.
• Check its connections. Get in touch with
your supplier to possibly change it.
• Check if the pressure of your network is
> 3 bar.
The plate will not
go up
• The electrical distributor is
faulty.
• Leak on the jack.
• Check its connections. Get in touch with
your supplier to possibly change it.
• Check the joints and all the unions. Get
in touch with your supplier.
The plate stays
in lower position
after pressing
• The timer will not count
down.
• See above.
8.5 POssIbLE brEAKDOWNs
UNPLUG THE MACHINE FROM THE ELECTRICITY AND AIR SUPPLY BEFORE
SERVICING!