Thermocet Hi-Fire Ligero, Инструкции по эксплуатации и монтажу

Страница: 7 / 32

Page 7
3.10 Setting the flame size / Extinguishing the fire
∗
After the burner is ignited, the flame size will automatically move into the maximum setting.
∗
Press to reduce the flame size and turn off the burner.
(Extinguishing the fire: “ STAND BY ”). (Pressing the key for a short time gradually reduces the flame.)
∗
Press to increase the flame. (Pressing the key for a short time gradually increases the flame.)
3.11 Switching the unit off.
∗
Press to reduce the flame size and turn the burner off (“
STAND BY ”).
∗
Then press the OFF key to turn the entire unit off, including the pilot flame.
∗
If the unit is not used for an extended period of time, you can turn the " O I ” switch, on the gas control
block, into the “ O ” position, in order to save battery life.
∗
In this case, it is also recommended you close the gas shut-off cock in the supply line.
Important: If, for whatever reason, the pilot light extinguishes, you must wait 5 minutes before igniting
the pilot light again.
Malfunction
∗
If the signals from the manual transmitter are not received adequately by the receiver, this may be caused
by:
∗
Flat batteries: replace the batteries.
∗
An electronic problem: can be solved by pressing the " RESET ” key on the receiver.
∗
Contact your fitter if the unit regularly turns off.
3.12 Replacing the batteries
∗
The batteries of the manual transmitter and receiver have a life span of approximately one year. The use of
alkaline batteries is recommended.
∗
The batteries need to be replaced when the following occur:
1. Manual transmitter: BATT appears on the display.
2. Receiver: long sound signals can be heard during the ignition.
1. Manual transmitter:
∗
Open the small lid on the back.
∗
Carefully remove the 9V block battery and loosen the battery from the contact holder. Do not pull the
wires!
∗
Connect the new battery and place it back into the transmitter. Close the lid.
2. Receiver:
∗
Carefully remove the entire receiver from the holder.
∗
Slide the small lid open.
∗
Remove the batteries from the battery holder.
∗
Place 4 new 1.5V batteries (type LR6 or AA) in the battery holder in the indicated manner. The spring
always needs to be against the minus (-) pole of the battery.
∗
Close the lid and place the receiver back into the holder.
Incorrect placing of the batteries can irreparably damage the electronics or power.
Only replace the batteries when the unit is completely turned off.