Thermocet Hi-Fire Ligero, Инструкции по эксплуатации и монтажу

Страница: 5 / 32

Page 5
3. REMOTE CONTROL
3.1 General
∗
The unit is operated using a radio-controlled remote control. This consists of a manual transmitter and a
receiver. The receiver is connected to the gas control block.
* The receiver and gas control block are located at the bottom of the unit.
3.2 Manual transmitter
∗
The transmitter uses a radio-controlled signal. The signal code is set at the factory, but can be adjusted if
required. (See 3.7)
3.3 Screen setup
∗
After fitting the batteries, simultaneous pressing of OFF and allows you to
change from °F (and 12-hour clock) to °C (and 24-hour clock), or vice versa.
∗
Wait a moment or press OFF to return to MAN mode.
3.4 Time setup
* For SET mode or program mode, simultaneously press and
* The time can be set while the screen is flashing.
* Press
to input the hour and to input the minutes.
* Wait a moment or press OFF to return to MAN mode.
3.5 Setting the desired temperature
∗
Press the SET -key briefly to select the required mode or
∗
Keep the SET –key pressed in until the screen starts flashing.
∗
Subsequently press or to set the required temperature.
∗
Wait a moment or briefly press the OFF -key to select the MAN mode.
∗
If the temperature setting needs to be switched off with (low battery usage), then lower until
appears on the screen.
3.6 Setting the timer: P1 and P2
∗
Press briefly on the SET -key to select the required mode
∗
Keep the SET –key pressed in until P1 (heating period 1) flashes on the screen.
∗
Set the commencement time of the first (1
st
) heating period by pressing on to input the hour, and on
to input the minutes.
∗
Briefly press the SET -key; P1 now appears on the screen. Set the time the first (1
st
) heating period needs
to end.
∗
Press the SET -key again to set the beginning and end of the second (2
nd
) heating period P2 ( ON ) and
P2 ( OFF ).
∗
Wait a moment or press OFF to return to MAN mode.
Manual transmitter