Thermo 3307, Руководство по эксплуатации и техническому обслуживанию

Страница: 9 / 57

Four stacking brackets (one shown at left) are
included in the parts bag shipped with each incu-
bator.
Figure 1-3
1. Unscrew and remove the 4 leveling feet from the unit to
be stacked on top and lift it onto the base unit. Align all
sides.
This incubator weighs 340 lbs. for Models 3307 &
3308, 410 lbs. for Models 3310 & 3311. Have suf-
ficient personnel available when lifting. Lift the
unit by the sides of the cabinet base to avoid plac-
ing stress on the outer door hinge.
2. Remove the hole plugs from the stacking bracket holes
(see Figure 1-5).
3. Align the holes in the brackets
with the mounting holes on the
sides of the top and bottom incu-
bator. Secure the two brackets
with the stainless steel screws
and washers provided in the
parts bag. See Figure 1-4.
4. The stacked incubators are ready for service.
c. Preliminary Cleaning
1. Using a suitable laboratory disinfectant, thoroughly
clean all interior surfaces.
d. Installing the Shelves
1. Install the pilasters, two on each side, with the tab facing
into the center of the chamber with their slots up. Press
downward on the top section of each pilaster to locate,
then release when in position (Figure 1-8). Fit each
pilaster securely into the indentations at each side of the
ceiling and the floor of the chamber. Figure 1-6 shows
the diffuser pan, pilasters, and shelf channels.
Note that there is a difference between the left and right shelf
channel. The channels are stamped as to which end goes to the
front of the unit.
2. Install the diffuser pan in the bottom of the unit with the
flanges down. See Section 9 at this point if your unit
includes a factory-installed datalogger (P/N 201912).
3. Install the shelf channels by placing the channel’s rear
slot over the appropriate rear tab on the pilaster. Pull the
shelf channel forward and engage the channel’s front
slot into the pilaster’s appropriate forward tab. Refer to
Figure 1-7.
Steri-Cult Incubator ____________________________________________________________Installation and Start-Up
1 - 3
Figure 1-7
Figure 1-6
Figure 1-4
Door
Sides of stacked units,
brackets installed
Back of stacked units,
brackets installed
Figure 1-5