Figure 2.26. Inserting the
reusable bearing hub
Figure 2.27. Closing the
bearing hub mounting latch
2. Close and engage the latch (Figure 2.27).
2.6.5 Drive shaft insertion
Use the following steps to insert the drive shaft through the motor
head.
1. Remove the latch pin from the safety cover on the motor and lift
the clear plastic safety cover (Figure 2.28).
Figure 2.28. Removing the
motor head latch pin and
safety cover
Thermo Scientific
Chapter 2
|
Setup and operating information
HyPerforma DS 300 Single‑Use Mixer User's Guide
|
32
