9. Carefully lower the bottom of the BPC into the drum with the
elbow in the drain line facing the drain port (if present) in the
bottom of the drum. Then pull the drain line through the bottom
front face of the drum.
10. Check to make sure the drain line and the support collar are
positioned correctly (if applicable).
11. Place the liner inside of the drum and fold the edge of the liner
over the top lip of the drum (Figure 2.17).
Figure 2.17. Folding the liner
over the lip of the drum
12. Roll the drum and dolly under the motor head of the docking
station (Figure 2.18).
Figure 2.18. Rolling the drum
and dolly under the motor
head
Note:
To properly place the drum under the docking station, the
motor head may need to be lifted. To operate the lift mechanism, see
section 2.6.2.
Thermo Scientific
Chapter 2
|
Setup and operating information
HyPerforma DS 300 Single‑Use Mixer User's Guide
|
26
