Thermo Scientific Orion Star LogR Meter, Руководство пользователя

Страница: 77 / 78

73 Thermo Scientific Orion Star LogR™ Meter User Guide
Autosampler Interfacing
Pausing the Autosampler
To pause the autosampler during operation, press . To resume operation, press
again.
Stopping the Autosampler
To stop the autosampler during operation and abort the run, press and hold for
about 3 seconds.
Moving the Electrode Arm
At the end of a run, when the electrode arm has returned
to home position and is lowered into beaker one, press
to lift the electrode arm and press again to
lower the electrode arm. See the diagram to the right. This
action is operational only when the autosampler is not
running and the electrode arm is in the home position.
Turning Off the Autosampler Function
To disable the autosampler, press in the measurement mode to enter the setup
menu. Press until is displayed on top line. Press until the arrow
icon points to the middle line and press until is displayed. Press until
the arrow icon points to the bottom line and press until OFF is displayed. Press
until the arrow icon points to the top line. Press to return to measurement
mode.
Autosampler Dip Switch Settings
The dip switch cover is located on
the rear panel of the autosampler
and a small Phillips head screw
driver is needed to remove the dip
switch cover. The ON position for the
dip switches is down and the OFF
position is up. To set the autosampler
dip switches to 9600 for Com 1,
adjust DIP switch 4 and DIP switch 5
to the OFF position (up).
DIP 1 DIP 2 DIP 3 DIP 4 DIP 5
Even Parity ON
No Parity OFF
9600 Baud OFF OFF
1200 Baud ON OFF
2400 Baud OFF ON
38500
Baud ON ON