Thermo Scientific DensityPRO, Инструкция по применению

Страница: 72 / 101

DensityPRO Specific Parameters
Parameter Type R/W Description
IOUT_MIN_CORRECTION CON R/W The correction factor for the current output at minimum.
IOUT1_VALUE S R The internal value of IOUT1.
IOUT1_VALUE_PERCENT S R The internal value of IOUT1 in percent.
LAST_STD S R The status of the last standardization cycle.
1 = full of carrier
2 = empty
6 = full of process
LUMP_STATUS S R The lump status.
MASS_FLOW_TIME_UNIT CON R/W The time units for the mass flow measurement.
2 = minutes 3 = hours
MASS_FLOW_UNIT CON R/W The mass units for the mass flow measurement.
4 = metric ton
5 = short ton
MATERIAL_TYPE CON R/W The material type that most closely matches the process material.
1 = slurry
2 = solution
3 = single phase
4 = emulsion
MAX_IOUT_VALUE CON R/W The maximum current output in mA (4.0 to 20.5 mA).
MEA_NUM_ALARM1_
ASSIGN CON R/W The measurement number ALARM1 is assigned to.
MEA_NUM_ALARM2_
ASSIGN CON R/W The measurement number ALARM2 is assigned to.
MEA_NUM_ALARM3_
ASSIGN CON R/W The measurement number ALARM3 is assigned to.
MEA_NUM_ALARM4_
ASSIGN CON R/W The measurement number ALARM4 is assigned to.
MEA_NUM_ALARM5_
ASSIGN CON R/W The measurement number ALARM5 is assigned to.
MEA_NUM_ALARM6_
ASSIGN CON R/W The measurement number ALARM6 is assigned to.
MEA_NUM_ALARM7_
ASSIGN CON R/W The measurement number ALARM7 is assigned to.
MEA_NUM_ALARM8_
ASSIGN CON R/W The measurement number ALARM8 is assigned to.
MEA_NUM_AT_CURRENT_
OUT_ALTMODE CON R/W The measurement sent to the current output in alternate mode.
MEA_NUM_AT_CURRENT_
OUT_PRIMODE CON R/W The measurement sent to the current output in normal mode.
C-10 DensityPRO with F
OUNDATION
™ fieldbus Application Guide Thermo Fisher Scientific