Thermo Scientific AquaSensors AquaChlor, Руководство пользователя

Страница: 18 / 43

Thermo Scientific AquaSensors
™
AquaChlor
™
Free Chlorine Monitor User Guide 16
Sample Chamber Mounting tools and equipment:

½ inch Drill with drill bit for appropriate wall anchor.

Four ¼ diameter bolts – 1.5 inches long.
 Four ¼ inch ID flat washers

Wrench to turn bolts

Level to insure the system is level when mounted
General Sample Chamber Mounting Instructions:
1.
Place the 12 inch x 12 inch panel on the wall where it is to be mounted and mark the placement of the
upper left hole.
2. Drill a mounting hole for the upper left corner with a masonry drill bit.
3. Mount the AquaChlor System with the upper left bolt.
4. Using a level, rotate the system until level, then mark the other three mounting holes.
5. Rotate the plate out of the way and drill the other three mounting holes.
6. Place all four bolts with washers and tighten. Use shims if necessary to insure the sample chamber is
level.
General Sample Chamber Plumbing Instructions:
1. The AquaChlor™ system has a water INLET and an OUTLET.
2. Barb fittings are provided for the INLET and OUTLET to accommodate 3/8 inch and 1/2 inch ID tubing
respectively.
3. When the INLET is to be directly plumbed rather than using tubing, remove the barb fitting and install
¼ inch NPT threaded pipe to the INLET.
4. When the OUTLET is to be directly plumbed rather than using tubing, remove the barb fitting and
install straight ½ inch NPT threaded pipe that extends to a vented drain. Pipe restrictions that result in
back pressure to the OUTLET are not allowed.
5. The sample supply must be between 250 to 750 ml/min (4 to12 gph). If the source is under pressure,
use an appropriate flow or pressure valve to obtain consistent flow.
6. Turn on water flow into the flow chamber.
7. Adjust the flow rate through the system with the inlet valve on the flow chamber. If the right port in the
flow chamber is not overflowing to the center drain, increase the flow through the system. If the left
port in the flow chamber is overflowing to the center drain, decrease the flow through the system.