Section 6 Safety Tips and Maintenance
Safety Tips
1. Use independent power supply.
2. Check if the local power supply
voltage is suitable for use.
3. Do not drag the power supply cable
when unplugging.
4. Do not use non-specified power cable
or damaged cable.
5. Service should only be performed by a
qualified professional.
6. The power supply must be unplugged
under the following situations:
(1). When the unit is moved
(2). When the electrical cabinet or the
moving component is opened
(3). When the equipment is
malfunctioning
(4). When the equipment is not in use
7. Check that the instrument and the
accessories are in good condition
before each operation.
Cleaning
In order to ensure the safe use of the
instrument, please follow the
manufacturer’s recommendations for
cleaning when cleaning the instrument.
◆
Unplug the power first when cleaning
.
◆
Wipe the instrument with a damp, soft
cloth or non-corrosive cleaning agent.
◆
Direct spray instruments are prohibited.
◆
Make sure that the instrument is
completely dry before operating it.
◆
Please wear gloves when cleaning.
Warning:
Avoid dripping detergent or
water into the inside of the instrument
during cleaning.
Clean Spill
If accidental spillage of liquids caused by
mishandling or contained breakage
occurs on the surface of the instrument,
please shut down the instrument and
clean up the liquid immediately.
If the liquid has already spilled into the
unit, cut off the power supply first and
immediately clean up the liquid at the
surface of the instrument. Place the
instrument in a ventilated and dry
environment for 24 hours before reuse. If
the instrument is not functioning after
drying for 24 hours, please contact the
manufacturer.
Warning:
The operator is not permitted
to gain access using a tool, to a part
which in normal use may be hazardous
live.
Digital Platform Rocker 12
Run and Stop
Press “ ” button and the instrument
will start running with the specified
settings and the Run indicator light will
be on.
The Time dispaly window will show the
cumulative time (Continuous Mode), or
remaining time (Timer Mode) and the
Speed/Tilt display window will show the
current speed/tilt.
Press “ ” button again and the
instrument will slow down until it stops.
The instrument will then be in standby
and the two display windows will show
the set values.
Finish Operation
After the operation is finished, press the
power switch at the back right side the
instrument and put it into the “O” state.
Unplug the instrument and store the
instrument according to the storage
guide.
Alarm System
Err1: If running speed does not match
the setting speed, the instrument will
have a three-time reboot, and after the
three reboots failed, there will be a
buzzer, and then Err1 will be displayed in
the Speed display window .
End of timer: The instrument buzzing
alarm, the "End" is displayed in the Speed
window.
When the instrument alarms, press any
key, the instrument is back to the
standby mode.
Power Recovery
If the power supply is cut off suddenly
while the instrument is in operation, the
unit will automatically run at the
previously set parameter upon power
restoration. The display windows will
flash. Press any button to stop flashing.
Mechanical Zero Correction
To ensure accurate and quality rocking,
the instrument will automatically run
mechanical zero correction in the
following situations:
1. First operation after the machine is
turned on.
2. First operation after the rocking speed
is reset.
3. After 4 hours of continuous operation
(speed
＞
50rpm);
After 8 hours of continuous operation
(speed
≤
50rpm).
Run
Stop
Run
Stop
11 Section 5 | Operation
