Figure 1
Figure 2
A1
A2
A3
A4
Figure 3
5.2 Installation of Two Trays
Only accessories that meet the
manufacturer's specifications shall be
used.
1. Remove the screw for rubber strip at
positions A1 to A4 as shown in the
figure 1.
2. Place the two trays on to the Stacking
Bars at position A1 to A4 shown in the
figure 2.
3. Fasten the screw for rubber strip on
the two trays as shown in the figure 3.
Warning:
(1). The maximum load on upper layer
cannot exceed 1Kg at 70rpm.
(2). It can be used with rubber
strips(88882103) to prevent the tube
falling off due to too large swinging
Angle, The direction of tube
placement as shown in the figure 4.
9 Section 5 | Operation
Figure 4
5.3 Installation
1. Connect all the components according
to the figures shown on page 4 of this
manual. Use grounded power outlet.
Ensure the machine is on a flat surface
prior to operating.
2. Press the power switch "I" side and
switch on the instrument.
5.4 Settings
Time Settings
1. Continuous mode
Press the Time setting knob. To decrease
time, rotate the knob counter clockwise/to
increase time, rotate the knob clockwise,
when the time display window shown
00:00,then press the knob with in 5sec to
confirm the setting, the digital tube will
stop flashing and the time setting is
complete. the instrument is in
continuous mode.
2. Timer mode
Press the Time setting knob. To decrease
time, rotate the knob counter clockwise/to
increase time, rotate the knob clockwise
then press the knob with in 5sec to confirm
the setting, the digital tube will stop
flashing and the time setting is complete.
the instrument is in timer mode.
Speed Settings
1. Press the “ ” button and the Speed
indicator light will be on.
2. Press the Speed/Tilt setting knob.
To decrease speed, rotate the knob
counter clockwise/to increase speed,
rotate the knob clockwise then press
the knob with in 5sec to confirm the
setting, the digital tube will stop flashing
and the speed setting is complete.
Tilt Angle Setting
1. Press “ ” button and the Tilt
indicator light will be on.
2. Press the Speed/Tilt setting knob.
To decrease tilt, rotate the knob
counter clockwise/to increase tilt,
rotate the knob clockwise, then press
the knob with in 5sec to confirm the
setting, the digital tube will stop flashing
and the tilt setting is complete.
Rocking Time Settings
Press the Time setting knob , The window
will show the time value. When the time
shown is between 00:01 to 99:59, the
default step of the instrument when
changing the time is 1 second. Continue
to turn the knob clockwise and the value
0100 will show on the Time display window.
When the time shown in between 0100
to 9999, the default step is 1 minute.
and the press the knob again within 5sec,
the digital tube stop flashing, instrument
will automatically take the value shown
as the set rocking time.
Mode
Mode
Digital Platform Rocker 10
