Thermo Scientific 678 Series, Руководство по эксплуатации и список запасных частей

Страница: 16 / 44

12A Water Still 4-1 Thermo Scientific
Section 4
Assembly
Refer to Figure 4-1 for the following steps:
1. Re-install the condenser F into the coupling R and clamp condenser in
place with springs Y.
2. Check orientation of trap E. If it is not level or tilted back toward the
boiler as shown in Figure 4-1, move the condenser F up in its bracket.
This will tilt trap as shown in Figure 4-1.
3. Tighten coupling R using 7/16" wrench. Coupling should be just tight
enough to prevent rotation with moderate hand pressure.
4. In the following steps, use warm water on connections for ease of
assembly.
a. Remove tape from 3/8" I.D. vinyl hose and connect to upper right
condenser outlet at Point A (Figure 4-1).
b. Remove tape from 3/8" I.D. vinyl hose and connect to lower right
condenser outlet at Point B (Figure 4-1).
Figure 4-1. Assembly